# Transaction not in mempool

**URL:** <https://bisq.community/t/transaction-not-in-mempool/7648>\
**Category:** Support\
**Created:** [May 10, 2019, 10:23am UTC](https://bisq.community/t/transaction-not-in-mempool/7648 "2019-05-10T10:23:21Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Delmonte](https://bisq.community/letter_avatar/delmonte/32/5_5575768a8748004e209b776fc1b2916d.png) [@Delmonte](https://bisq.community/u/Delmonte)\
**Post date:** [May 10, 2019, 10:23am UTC](https://bisq.community/t/transaction-not-in-mempool/7648/1 "2019-05-10T10:23:21Z")

</div>

I was hoping if anybody could help me out or maybe experiences similar problems with this. Recently I bought btc with Bisq (V1.1.1) and I wanted to move them to my Bitcoin Core full node (0.18.0).

However, the transaction has a transactionID and in the node it is currently noted as pending and unconfirmed, but it does not show up in the mempool or on [Blockstream.info](https://Blockstream.info). (The TXID is: a548d9624aff2af13ad412de213aa6df51da23fb80c5c2eecfbdb587529fdf89)

Currently, Bisq states that it has 9 P2P network peers and that 2 peers have seen the transaction and the node has 9 active connections. I have done this before, so I think it may be an issue after updating either Bisq or Bitcoin Core.

I have used a low transaction fee (1 sta/byte), but I this shouldn’t prevent the transaction from showing up in the mempool.

Does anybody know what is the reason for this? Any help is appreciated!

---

<div class="post-metadata">

**Author:** ![GOran](https://bisq.community/letter_avatar/goran/32/5_5575768a8748004e209b776fc1b2916d.png) [@GOran](https://bisq.community/u/GOran)\
**Post date:** [May 10, 2019, 9:37pm UTC](https://bisq.community/t/transaction-not-in-mempool/7648/2 "2019-05-10T21:37:49Z")

</div>

most nodes dont propagate 1sat/byte transaction so it takes much longer.

you can see the transaction at [blockchain.com](http://blockchain.com)

you just need to wait a very long time.

---

<div class="post-metadata">

**Author:** ![alexej996](https://bisq.community/user_avatar/bisq.community/alexej996/32/491_2.png) [@alexej996](https://bisq.community/u/alexej996)\
**Post date:** [May 11, 2019, 10:09am UTC](https://bisq.community/t/transaction-not-in-mempool/7648/3 "2019-05-11T10:09:36Z")

</div>

Bitcoin Core nodes have a minimum relay fee of 1 sat/byte by default.  
As GOran said, this could be the case.

You can use cmd+e to withdraw your coins again after setting a little bit higher fee.